RODE VideoMic Pro

224,91 € * mit MwSt.
189,00 € ohne MwSt.

zzgl. Versandkosten

Lieferzeit ca. 3-5 Tage

  • SW12694
RODE VideoMic Pro On-camera Microphone The RØDE VideoMic Pro is a true shotgun microphone... mehr
Produktinformationen "RODE VideoMic Pro"

RODE VideoMic Pro On-camera Microphone

The RØDE VideoMic Pro is a true shotgun microphone designed for use with camcorders, DSLR cameras and portable audio recorders as a source of primary and reference audio.

At the heart of the VideoMic Pro is a high resolution 1/2" condenser capsule that provides broadcast quality audio via a 3.5mm minijack connector (outputting the mono signal to both left and right channels). A super-cardioid polar pattern ensures that surrounding audio is minimised, and your recording is focused on the subject in front of the camera.

An innovative suspension system separates the VideoMic Pro capsule and electronics from its mount, providing isolation from external physical factors that may cause unwanted rumble and vibrations in the microphone. A lightweight and flexible yet robust multi-strand cable provides significantly lower noise transference than traditional audio cable while ensuring a high definition signal.

Easily accessible on the rear face of the microphone are the power, filter and level controls. In addition to the microphone's native 40Hz-20kHz response a selectable high-pass filter at 80Hz is available, which will prevent low end noise such as air conditioners and traffic from being recorded.

Below these controls are the level settings, which attenuate or boost the recorded level as required. The -10dB level attenuation (or PAD) is ideal for recording loud sound sources, such as live music, motorsport, or interviews where the subject is very close to the camera. The +20dB level boost is designed for use with DSLR cameras such as the Canon 5DMkII, Canon 7D, Canon 1D, Canon 550D/T2i, Canon 60D, Nikon D7000, Nikon D5100, Panasonic GH1 and Panasonic GH2. This boost in the microphone output allows the user to reduce the camera's preamp level (or mic-input level), effectively reducing the amount of noise generated by the camera's comparatively low quality audio circuitry.

The microphone uses a standard sized shoe mount for on camera use, and features a 3/8" thread in the base of the mount for easy boom pole mounting. Note that cameras with proprietary shoe mounts will require an adaptor or alternative mounting solution.

The VideoMic pro is battery powered, and provides over 70 hours recording from a single 9V battery.

The RODE VideoMic Pro compact directional on-camera microphone is covered by RØDE Microphones' industry leading 10 year warranty.

Technical data

Acoustic Principle Line Gradient
Active Electronics JFET impedance converter
Capsule 0.50"
Polar Pattern Supercardioid - Picks up the front and sides and rejects 150° to the rear
Address Type End
Frequency Range 40Hz - 20kHz
Output Impedance 200Ω
Maximum SPL 134dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Maximum Output Level 6.9dBu (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity -38.0dB re 1 Volt/Pascal (12.60mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted) 20dB-A
Power Options 9V battery powered (Over 70 hours operation from 9V alkaline battery)
Weight 85.00 gm
Dimensions 95.00 mm x 43.00 mm x 150.00 mm
Output Minijack/3.5 mm Output
Warranty 1 year with free extension to 10 years

Frequency Response

rode_videomic-pro_2

Polar Response

rode_videomic-pro_3

Weiterführende Links zu "RODE VideoMic Pro"
rode ntg-2 RODE NTG-2
224,91 € * mit MwSt.
189,00 € ohne MwSt.

RODE Stereo VideoMic Pro RODE Stereo VideoMic Pro
224,91 € * mit MwSt.
189,00 € ohne MwSt.

rode ntg3 Rode NTG-3 super-cardioid shotgun microphone
593,81 € * mit MwSt.
499,00 € ohne MwSt.