Mole Richardson 18” Windmachine Moleffect Type 6971

Mole Richardson 18” Windmachine Moleffect

Type 6971

This Mole Richardson 18” Windmachine can now be operated manually or off a DMX Control Console along with all your other lights and special effects. With Mole Richardson´s new built-in DMX control panel you can daisy chain and signature many windmachines and control them in multiple combinations from a DMX Control Console. This unit can be operated with 120 or 240 volts A.C. or D.C. current and is designed to create maximum air-flow with minimum noise for Hollywood sound stage use. A solid state control varies the speed  of the fan to produce wind effects from a light zephyr to a stiff breeze.

This Mole Richardson Moleffect is useful not only for routine wind effects, but also for dispersing snow flakes, creating a localized dusty breeze, etc. Radial vanes columnate air-stream, vanes may be removed for wide dispersion. At high speed the fan may be used to cool or ventilate a set or to clear smoke. The unit sets on the floor or mounts on a stand. Equipped with a Roll Bar for ease of handling

Windmachine Moleffect SPECIFICATIONS

WINDMACHINE: Mole Richardson Type 6971
RATING: 120/240 volts, A.C. or D.C., 5 amps max
VOLUME: 2390 cubic ft. per minute
AIR VELOCITY: 1700 ft. per minute
MOTOR: 1/3 H.P., D.C. brushless, totally enclosed, ball bearing, solid base, variable speed motor, mounted to housing by rubber flex-bolt mounts
SWITCH: Toggle switch with “OFF-ON” plate mounted on operating side of housing
CABLE: Attached 7.62 m, Type SO, 3 conductor #16 AWG (when ordering specify type of plug required)
CONTROL KNOB: Regulate fan speed, mounted on operating side of housing. Speed indicator dial numbered 1 through 10
ELECTRONIC MOTOR CONTROL MODULE:Mounted below motor support
FAN: Three-blade, 45.72 cm diameter
GUARDS: Welded steel wire
AIR GUIDE: Aluminum radial vanes columnate air flow
CONSTRUCTION: Sheet steel housing and steel wire guards
ROLL BAR: Tubular steel
YOKE: Tubular steel with removable 2,86 cm dia. steel yoke pin
DMX CONTROL PANEL: Built in—Used to decode the incoming digital signal (DMX) to 0-10V D.C. Output
INPUT CONNECTOR: 5-pin
OUTPUT CONNECTOR TO NEXT DMX MODULE: 5-pin
SIZE: 66,66 cm diameter, 50.8 cm length
FINISH: Maroon Powder Coat Enamel and Electroplated Guards
WINDMACHINE WEIGHT: 40.6 kg